Claas C450 Folding Do Mega Medion (431) Combines Assembly Instruction EN

File List:

00 0290 143 2.pdf
00 0292 437 0.pdf
00 0292 634 0.pdf
00 0292 903 0.pdf
00 0299 838 0.pdf
00 0300 374 1.pdf
00 0303 568 0.pdf

00 0299 838 0.pdf:

Introduction
Introduction
Table of contents
Table of contents
Attention!
Special note
Type plate / serial number
Safety rules
Safety rules
Identification of warning and danger signs
Correct use of the vehicle
General safety and accident prevention regulations
Safety Locks
Cylinder safety lock
Reel supports
Insert the reel supports
Remove the reel supports and store them away
Safety decals with pictorials
Specifications
Weights / Dimensions / Safety devices
Weights / Dimensions
Safety feature:
Setting the slipping clutch
Prior to operation
Carry out prior to initial operation
Driving lights for road use
Driving lights for road use
Switching over the driving lights
Cutterbar cylinder
Ancillary equipment
Additional weights
MEDION 340 – 310 / MEGA 360 / 350
Liquid filler for the steering axle wheels
Fitting the cover weights
Scope of components – Cover weights
Scope of components – steering axle weights
Steering axle weights
Fitting the steering axle weights (Additional equipment)
Fitting and Operation
Fitting additional equipment
Fitting stops in the feeder housing
Scope of parts – Fitting
Fitting the stops
Lock the cutterbar at the sides
Modifying the cutterbar Auto-Contour for machines without Auto-Contour
Fitting the switching device and the driving lights
Shortening the flat key MEGA 360 / MEDION 340
Setting the additional headlights
Fitting the cutterbar
Tilting the cutterbar from the transport position
Fitting and removing the cutterbar.
Fitting the cutterbar – folded – (Cutterbar in the transport position)
Aligning the cutterbar (Cutterbar without Auto-Contour)
Connecting the hydraulic hoses
Connecting the plug
Changing the cutterbar from transport position to operating position
Changing the cutterbar from operating position to transport position
Removing the cutterbar – folded in –
Fitting the cutterbar – unfolded – (Cutterbar in operating position)
Connecting the universal drive shafts
Connecting the hydraulic hoses
Connecting the plug
Removing the cutterbar – unfolded – (Cutterbar in operating position)
Adjustments to the cutterbar
Crop dividers
Crop lifters
Reel speed
Intake auger
Cutterbar skids
Malfunction
Cause or Remedy
Maintenance
Transmissions
Knife drive casing
Oil filling:
(Fig. 1, 2)
(Fig. 2)
Check the oil level:
Angle drive for the reel drive
Knife drive
Drive chain tensioning
Cleaning the guide rail of the locking cylinder
Adjusting the double fingers
Lubrication chart
Lubricants and notes