Claas Corto 270 S N Nc (649) Mower Assembly Instruction EN

File List:

00 0288 077 1.pdf
00 0290 143 2.pdf
00 0293 852 9.pdf
00 0300 374 1.pdf
00 0922 498 0.pdf
00 1325 214 4.pdf
00 2688 247 0.pdf

00 0293 852 9.pdf:

1 Introduction
Introduction
Validity
2 Table of contents
3 Preface
Of special importance
Identification plate
Intended use
Avoidable incorrect applications
De-commissioning and disposal
Identification of warning and danger signs
General safety regulations and safety precautions
Attached machines
Trailed machines
PTO operation
Hydraulic system
Maintenance
Noise pressure level
Safety decals with pictorials
5 Specifications
CORTO 310 S
CORTO 310 N
CORTO 270 S
CORTO 270 NC
CORTO 270 N
Axle loads, minimum ballast and total weight calculation
Calculating the minimum ballast front
Calculating the minimum ballast rear
Calculating the actual front axle load
Calculating the actual total weight
Calculating the actual rear axle load
Tyre carrying capacity
Noise level
6 Assembly
Assembly CORTO 310 S / 310 N / 270 S / 270 N with swath device
Assembly CORTO 270 S with conditioner
Assembly CORTO 270 NC
Fitting cutting blades
Fitting ropes
Hydraulics
Machine fitting for the first time
7 Prior to operation
Check every time prior to operation
Hitching up
Hitch pin
Adjusting the universal drive shaft
Adapting the length
Fitting the universal drive shaft
Mounting the universal drive shaft
Wide angle equal running linkage
Hydraulics
Prop stand
Fitting the machine
Prior to transportation
Driving on public roads
8 Operation
Operation
Working position
Transport position
Cut height adjustment
Collision safety device
Flotation springs
Conditioner
Swath device
Recommendations for environmental protection
Optional equipment
Increasing the height of the skid plate for high cutting
Domed mower blades
Reinforced mower blades
Changeover kit for PTO speed 1000 r.p.m.
Changeover set swath device with cover
Hydraulic connection parts for the tractor
Slip-yoke kit
High cutting device
9 Maintenance
Important maintenance instructions
Hydraulic system
Energy accumulators
Lubrication
Drive systems
Tensioning the drive belts
Gearbox and gear casing
Conditioner gearbox
Mower blades
Changing the mower blades
Mower blade holders
Cut height adjustment
Swath device
Conditioner
Fitting/removal of the conditioner tines
Hydraulic system
Hydraulic hose connections
Hydraulic cylinders
Universal drive shaft
Bolted connections
Fasteners
End of season storage
10 Lubrication chart
Safety rules
Lubricants
Lubrication