Claas Disco 8600 C Duo (F58) Mower Technical System ES

File List:

00 0290 827 3.pdf

00 0290 827 3.pdf:

DISC 9300/8600
Introduction
Safety instructions
Safety measures and danger notices
Manual validity
CCN Explanation
CCN (CLAAS Component Number)
General indications
Electrical regulations
Hydraulic regulations
CCN (CLAAS Component Number)
09 Hydraulic
0920 Valves
DISCO 9300 – 8400 valve block with reverse device
DISCO 9300 – 8400 valve block without reversing device
0980 Hydraulic connection diagram
Hydraulic connection diagram DISCO 9300 – 8600 with reverse device
Function description – connection to the tractor hydraulic system
Hydraulic connection diagram DISCO 9300 – 8600 without reversing device
Function description – connection to the tractor hydraulic system
10 Install. electrical/electronic
1012 Modules / sensors
Mower control module (A68), additional mower control module (A111)
Module pin assignment (A68, A111) – socket X1
Module pin assignment (A68, A111) – socket X2
1080 Electronic connection diagram
Electrical connection diagram DISCO 9300 – 8600 with CST (CLAAS Standard Terminal)
Electrical connection diagram DISCO 9300 – 8600 with ISO-BUS
Diagnosis according to fault codes
FMI (Failure Mode Indicator) fault code
FMI fault code (Failure Mode Indicator)
General indications
FMI 00 (signal too large)
FMI 01 (signal too small)
IMF 02 (implausible signal)
FMI 03 (voltage too high)
FMI 04 (voltage too low)
FMI 05 (current too low)
FMI 06 (current too high)
FMI 07 (mechanical failure)
FMI 08 (frequency signal defective)
IMF 09 (communication failure)
FMI 10 (signal change too fast)
IMF 11 (multiple failure)
FMI 12 (defective ECU)
FMI 13 (signal outside calibration range)
IMF 16 (non-existent parameter)
FMI 17 (ECU not responding)
FMI 18 (power supply failure)
FMI 19 (software requirements not met)
IMF 95 (no signal change)
FMI 96 (CAN-Bus system defective)
IMF 97 (implausible state)
IMF 98 (warning)
IMF 99 (Info)
Error codes
DISCO 9300 fault codes
DTC (Diagnostic Trouble Code) Summary
Location of components
Hydraulic installation
3000 Hydraulic Cylinders
4000 Choke
5000 Pressure accumulators
6000 Valves with mechanical drive
7000 Hydraulically Actuated Valves
9000 Measuring points / indicator instruments
Electrical installation
To Modules
B Sensors
and electromagnetic valves