Claas Lexion 470 Montana (541) Combines Operator Manual ES

File List:

00 0298 982 2.pdf

00 0298 982 2.pdf:

Introduction
Introduction
Security measures
Security measures
Safety stickers with danger symbols_x0011_graphics
Technical data
CLAAS LEXION 470 Montana
CLAAS LEXION 470 Montana
CLAAS LEXION 470 Montana
CLAAS LEXION 470 Montana
CLAAS LEXION 430 Montana
CLAAS LEXION 430 Montana
CLAAS LEXION 430 Montana
CLAAS LEXION 430 Montana
Before starting_x0011_start
Gradient system
Driver platform box
Scorecard
Unevenness system control desk
Machine operation
Axle (wheel angle)
Cutting mechanism
Axle (wheel angle) and cutting mechanism
Cutting mechanism adjustment key block (yellow)
Key block for axis adjustment (green)
Calibration
Inclinometer Calibration
Calibration of wheel cylinders
Cutting angle calibration
Transverse Tilt Calibration
Straw channel calibration (feed_x0011_channel)
System information
Inclinoinfo
Access ladder
Front staircase
Check control lights
Drive the combine
Rotary switch for engine speed
Gear change
Maneuver
Hydrostatic advance
To start the engine
Shooting characteristics
Steer the machine
Footbrake
Parking break
Release the parking brake mechanically
Place the gears in 0 (neutral position)
Differential lock
Connect the differential lock
Disconnect the differential lock
Incident, possible causes and solutions
Maintenance – Machine_x0011_base
Maintenance and lubricant tables
Maintenance table
Lubricants table
Differential and axle mounts
Check the oil level
Oil change
wheel cranks
Check the oil level
Oil change
planetary gear
Check the oil level
Oil change
2 speed gearbox
Check the oil level
Oil change
Adjust the slewing ring guide rollers
Adjust the inductor to regulate the cutting angle
Adjust the inductors for the wheel cranks
Maintenance – Engine
Important information for the_x0011_maintenance
Important information for maintenance and safety
Maintenance and lubricant tables
Maintenance table
Lubricants table
Greasing scheme
Lubricants and indications