Claas LEXION 560-540 (584) Combine Operator Manual DE

File List:

– 00 0293 947 1.pdf
– 00 0294 649 1.pdf
– 00 0295 270 0.pdf
– 00 0299 409 7.pdf

00 0293 947 1.pdf

Table of Content:
2 7 Maintenance
2.1 7.1 Important maintenance instructions
2.2 7.2 Maintenance tables

00 0294 649 1.pdf

Table of Content:
2 1 Introduction
2.1 1.1 General information
3 2 Technical data
3.1 2.1 CLAAS LEXION 600 Terra-Trac
3.2 2.2 CLAAS LEXION 580 Terra-Trac
3.3 2.3 CLAAS LEXION 570 Terra-Trac
3.4 2.4 CLAAS LEXION 560 Terra-Trac
4 3 Security
4.1 3.1 Note
4.2 3.2 Warning symbol
5 4 Scope of delivery
5.1 4.1 Rubber half-track
6 5 Cultivation
6.1 5.1 Rubber half-track
7 6 Work input
7.1 6.1 Operation
8 7 Maintenance
8.1 7.1 Important maintenance instructions
8.2 7.2 Maintenance tables
9 8 Lubricatio 10.11 T

00 0295 270 0.pdf

Table of Content:
2 1 Introduction
2.1 1.1 General information
3 2 Before commissioning
3.1 2.1 Combine harvesters drive with mechanical / electro-hydraulic drive control
4 3 Maintenance – basic machine
4.1 3.1 Lubricant tables
5 4 Maintenance Motor
5.1 4.1 Maintenance tables
7 1 Introduction
7.1 1.1 General Information
8 2 Prior to operation
8.1 2.1 Driving the combine with mechanical / electro-hydraulic ground drive control
9 3 Maintenance – Basic machine
9.1 3.1 Lubricants charts
10 4 Engine maintenance
10.1 4.1 Maintenance schedules
12 1 Introduction
12.1 1.1 General Councils
13 2 Avant la mise en service
13.1 2.1 Conduite de la moissonneuse-batteuse with commande mecanique / lectrohydraulique d’avancement
14 3 Entretien – machine de base
14.1 3.1 Tableaux des lubricants
15 4 Maintenance motor
15.1 4.1 TableauGeneral indications
18 2 Prima della messa in esercizio
18.1 2.1 Advancement of the rental engine with mechanical command / electric hydraulic
19 3 Manual – macchina base
19.1 3.1 Table of lubricants
20 4 Manual engine
20.1 4.1 Manual table
22 1 Introduction
22.1 1.1 General indications
23 2 Antes de la puesta en marcha
23.1 2.1 Conducir the cosechadora with an accionamiento del advance mecnico / electro-hidrulico
24 3 Mantenimiento – Machine base
24.1 3.1 Cuadros de lubricants
25 4 Mantenimiento del motor
25.1 4.1 Tablas de mantenimiento

00 0299 409 7.pdf

Table of Content:
2 1 Introduction
2.1 1.1 General information
3 2 General information
3.1 2.1 Road traffic
3.2 / 550 / 540 / 540 C
5.2 4.2 CLAAS LEXION 530 / 520
5.3 4.3 CLAAS LEXION 510
6 5 Before commissioning
6.1 5.1 General information
6.2 5.2 Cabin
6.3 5.3 Lighting and sockets
6.4 5.4 Promotion ladder
6.5 5.5 Side flaps
6.6 5.6 Mudguard / side panel / trailer frame / transport trolley
6.7 5.7 Steering axles (standard cleaning system)
6.8 5.8 Additional weights steering axle
6.9 5.9 Cutting unit hydraulic cylinder
6.10 5.10 Pressure accumulator
6.11 5.11 Twin wheels
6.12 5.12 Grain tank
6.13 5.13 Combine harvesters drive with mechanical drive control
6.14 5.14 CLAAS autopilot (corn picker)
6.15 5.15 CLAAS autopilot (grain cutter)
6.16 5.16 Notes on coupling/uncoupling trailers
7 6 Attaching and removing the cutting unit
7.1 6.1 Attaching the cutting unit
7.2 6.2 Dismantling the cutting unit
8 7 Operation CEBIS (version 8.23)
8.1 7.1 CLAAS on-board information system CEBIS
8.2 7.2 CEBIS monitor and rotary switch
8.3 7.3 Rotary switch D
8.4 7.4 Before initial commissioning
8.5 7.5 Driving image
8.6 7.6 Harvest image
8.7 7.7 Montana regulation
8.8 7.8 CLAAS CRUISE PILOT
8.9 7.9 Yield Mapping
8.10 7.10 Flagging
8.11 7.11 GPS
8.12 7.12 Presets Haspel
8.13 7.13 Presets attachment
8.14 7.14 Section switching
8.15 7.15 Yield measuring device
8.16 7.16 Yield measurement
8.17 7.17 Fruit-dependent setting
8.18 7.18 Register
8.19 7.19 Setting
8.20 7.20 Motor utilization
8.21 7.21 Alarms
8.22 7.22 Messages
8.23 7.23 Malfunction / Remedy – Yield measuring device
8.24 7.24 Guide values for pulses/100 m
9 8 Operation – basic machine
9.1 8.1 HP feed channel
9.2 8.2 Standard feed channel
9.3 8.3 Threshing organs
9.4 8.4 Shaker
9.5 8.5 Cleaning (standard cleaning system)
9.6 8 Chaff Blower
9.11 8.11 Straw distributor
9.12 8.12 Sieving and threshing tables LEXION 560 – 510 (standard cleaning system)
9.13 8.13 Unawning
9.14 8.14 Malfunction, cause or remedy – basic machine
10 9 Maintenance – basic machine
10.1 9.1 Important maintenance instructions
10.2 9.2 Maintenance tables
10.3 9.3 Lubricant tables
10.4 9.4 Hydraulic system
10.5 9.5 Gearbox / Brakes
10.6 9.6 HP feed channel
10.7 9.7 Standard feed channel
10.8 9.8 Elevator chains
10.9 9.9 Drive belts / drive chains
10.10 9.10 Cabin / Air conditioning
10.11 9.11 Fire extinguisher
10.12 9.12 Compressed air system (additional equipment)
10.13 9.13 Straw chopper with radial distributor
10.14 9.14 Straw chopper with standard distributor
10.15 9.15 Winterization
11 10 Maintenance – Motor
11.1 10.1 Important maintenance instructions
11.2 10.2 Maintenance tables
11.3 10.3 Lubricant tables
11.4 10.4 Engine overview
11.5 10.5 Fuel system / engine oil
11.6 10.6 Cooling system
11.7 10.7 Dry air filter
11.8 10.8 Three-phase generator
11.9 10.9 Electrics / Electronics
11.10 10.10 Malfunction, possible cause or remedy
11.11 10.11 Winterization
12 11 Lubrication plan
12.1 11.1 Lubrication points