Claas Markant 650 (776) Balers Assembly Instruction EN

File List:

00 0290 143 2.pdf
00 0292 437 0.pdf
00 0300 374 1.pdf
00 0302 088 0.pdf
00 0302 089 0.pdf
00 1325 214 4.pdf
Assembly instructions MARKANT 650 9YFQ-1.71 SKD.pdf

Assembly instructions MARKANT 650 9YFQ-1.71 SKD.pdf:

MARKANT 6509YFQ-1.71
Table of contents
To this manual
General information
General points
Machines affected
General information
General points
Use in accordance with the original specifications
Safety instructions
Definition of hazard information
General safety and accident prevention advice
Parking the machine
Bill of material
Overview and functions
Overview, front right-hand side
Overview, front left-hand side
Overview, rear right-hand side
SKD components – MARKANT
Contents of the feed chamber
Contents of the main chamber (above and on the left-hand side)
Contents on wheel and axle side
Contents of the twine box
Standard bolts
Machine preparation
Equipment required
Securing the baler
Tightening torques
Basic operations
Baling piston at front dead centre
Manual rotation of the flywheel
Removing the flywheel guard
Fitting the flywheel guard
Manually starting tying
Preparation
Fitting the main chamber and the axle
Fitting the drawbar
Fitting the feed chamber to the axle
Fit the transmission
Fitting the bale chamber to the main chamber
Fitting the rear components
Fitting the hydraulic components
Pick-up hydraulic cylinder*
Drawbar hydraulic cylinder*
Fitting the pick-up
Fitting the needle protection
Fitting the bale chamber (upper pressure plate)
Fitting the covers
Fill the drive gearbox with oil
Checks and settings