Claas ROLLANT 520, 340 (760) Baler Technical System DE

File List:

– 00 0294 940 1.pdf
– 00 0294 946 0.pdf
– 00 0303 030 2.pdf

00 0294 940 1.pdf

Table of Content:
2 1 Module
2.1 Module representation
2.2 Module assignment
3 2 circuit diagrams
3.1 01a Wiring diagram Rollant 340 – 355 Type 760, 762, 763, 764 with standard terminal
3.2 01b Wiring diagram Rollant 340 – 355 Type 760, 762, 763, 764 with Medium Terminal
4 2 circuit diagrams
4.1 01d Main power supply Rollant 355 Comfort Type 764 with Communicator
4.2 04d CAN bus, circulation check valve Rollant 355 Comfort Type 764 with Communicator
4.3 06d CAN bus, power supply module Rollant 355 Comfort Type 764 with Communicator
4.4 07d Rotocut Rollant 355 Comfort Type 764 with Communicator
4.5 11d Binding release Rollant 355 Comfort Type 764 with Communicator
4.6 12d open/close tailgate Rollant 355 Comfort Type 764 with Communicator
4.7 Raise / lower 20d pick-up Rollant 355 Comfort Type 764 with Communicator
4.8 32d lighting Rollant 355 Comfort Type 764 with Communicator

00 0294 946 0.pdf

Table of Content:
2 1 ROLLANT 340-355 Standard
2.1 Total hydraulics
2.2 Valve block I – Rotocut knife ON / OFF
2.3 Valve block II – pressure relief valve pressing pressure, service valve pressing chamber
2.4 Lubricating oil pump (hydraulic operated)
3 2 ROLLANT 355 RC Comfort
3.1 Total hydraulics
3.2 Valve block II – pressure relief valve pressing pressure, service valve pressing chamber
3.3 Valve block III – reverse rotor
3.4 Valve block V – circulation check valve, open/close tailgate
3.5 Throttle check valve one-sided

00 0303 030 2.pdf

Table of Content:
1 ROLLANT 520
2 Table of Contents
3 Introduction
3.1 Safety instructions
3.2 Validity of the instructions
4 CCN Declaration
4.1 CCN (CLAAS Component Number)
5 CCN (CLAAS Component Number)
6 09 Hydraulics
6.1 0920 Valves
6.2 0980 Hydraulic circuit diagrams
7 10 Electrics / Electronics
7.1 1012 modules / sensors
7.2 1080 electrical circuit diagrams
8 45 Press device
8.1 4500 Press device
9 46 Binding system
9.1 4610 Yarn binding
9.2 4615 Net binding / film binding
10 75 Central lubrication
10.1 7515 Lubrication system / lines
11 Location of the components
11.1 Electrics
11.2 Hydraulics