IMT Series 60 PTO Air Compressor OPERATORS AND PARTS Manual 301420 32399

Table of Content:

1 ELECTRONIC MANUALS
2 GENERAL ARRANGEMENT
3 SPECIFICATIONS
4 TYPICAL INSTALLATION
5 SAFETY INFORMATION
5.1 AIR COMPRESSOR SAFETY PRECAUTIONS
5.2 SUB-ZERO TEMPERATURE OPERATION INSTRUCTIONS
6 COMPRESSOR TERMINOLOGY
6.1 ATF
6.2 AIR/OIL COALESCER
6.3 CFM
6.4 LOAD CONTROLLER
6.5 OIL SUMP
6.6 PSI
6.7 SAFETY VALVE
6.8 SHUTDOWN SWITCH
6.9 SIDE MOUNT PTO
6.10 COMPRESSOR ASSEMBLY
6.11 PRINCIPLES OF OPERATION
6.12 SYSTEM LUBRICATION
6.13 OIL SUMP
6.14 ELECTRICAL AND SAFETY CIRCUIT SYSTEM
6.15 AUTOMATIC BLOW DOWN VALVE
6.16 SYSTEM CONTROL
6.17 DISCHARGE PRESSURE REGULATOR VALVE
6.18 INLET VALVE
6.19 CONTROL SYSTEM OPERATION
7 INSPECTION, LUBRICATION, AND MAINTENANCE
7.1 LUBRICATION AND MAINTENANCE CHART
7.2 LUBRICANT RECOMMENDATIONS
7.3 LUBRICANT CHARACTERISTICS
8 MAINTENANCE
8.1 COMPRESSOR OIL SUMP FILL, LEVEL, AND DRAIN
8.2 GREASE
8.3 AIR INTAKE FILTER
8.4 AIR/OIL COALESCER
8.5 OIL RETURN LINE
8.6 OIL FILTER
8.7 OIL COOLER
8.8 SHAFT SEAL INSTALLATION INSTRUCTIONS
8.9 PTO
8.10 HYDRAULIC PUMP OPTION
9 TROUBLESHOOTING
9.1 TRUCK ENGINE WILL NOT START
9.2 UNPLANNED SHUTDOWN
9.3 IMPROPER DISCHARGE PRESSURE
9.4 SUMP PRESSURE DOES NOT BLOW DOWN
9.5 OIL CONSUMPTION
9.6 ENGINE LUGGING
9.7 COALESCER PLUGGING
9.8 HIGH COMPRESSOR DISCHARGE TEMPERATURE
10 COMPRESSOR OPERATION
10.1 STARTING/STOPPING
10.2 COMPRESSOR OPERATION
10.3 OPERATING CONDITIONS
11 FlLASH RECOVERY PROCEDURE FOR ROTARY COMPRESSORS
12 AIR/OIL SCHEMATIC-20019 & 20031-DWG
13 AIR/OIL SCHEMATIC-20021-DWG
14 AIR/OIL SCHEMATIC-20028 & 20032
15 AIR/OIL SCHEMATIC-PARTS
16 CONTROL HOSE PORT CALL OUTS
17 AIR INLET SYSTEM
18 OIL COOLING SYSTEM-20019 & 20031
19 OIL COOLING SYSTEM-20021, 20028 & 20032
20 OIL COOLING SYSTEM-PARTS
21 COMPRESSOR MOUNTING SYSTEM-DWG
22 COMPRESSOR MOUNTING SYSTEM-PARTS
23 DISCHARGE SYSTEM-20019 & 20031-DWG
24 DISCHARGE SYSTEM-20021-DWG
25 DISCHARGE SYSTEM-20028 & 20032-DWG
26 DISCHARGE SYSTEM-PARTS
27 DISCHARGE SYSTEM-PARTS (cont)
28 PTO AND DRIVELINE SYSTEM-DWG
29 PTO AND DRIVELINE SYSTEM-DWG
30 PTO AND DRIVELINE SYSTEM-PARTS
31 HARNESS-ELECTRICAL SYSTEM (F-SUPERDUTY DIESEL/MNL & AUTO TRANS)
32 ELECTRICAL SYSTEM (F-SUPERDUTY DIESEL/MNL TRANS)
33 ELECTRICAL SYSTEM (F-SUPERDUTY DIESEL/AUTO TRANS)
34 MISC PARTS-BOX (6X6X12) F-450 ’97’ DIESEL MNL TRANS
35 BOLT BAG PARTS LOCATED IN BOX
36 5, & 10 GPM PUMP OPTIONS FOR CRANE PACKAGES-DWG
37 5, & 10 GPM PUMP OPTIONS FOR CRANE PACKAGES-PARTS
38 RECOMMENDED SPARE PARTS LIST
39 QUESTIONNAIRE SERVICE