Table of Content:
1 ELECTRONIC MANUALS
2 TABLE OF CONTENTS
3 IMT SERIES 85 ROTARY SCREW COMPRESSOR SPECIFICATIONS
4 SAFETY
5 AIR COMPRESSOR SAFETY PRECAUTIONS
6 COMPRESSOR TERMINOLOGY
7 DESCRIPTION OF COMPONENTS
7.1 COMPRESSOR ASSEMBLY
7.2 LUBRICATION SYSTEM
7.3 OIL SUMP
7.4 SAFETY VALVE
7.5 AIR/OIL COALESCER
7.6 OIL RETURN LINE
7.7 MINIMUM PRESSURE ORIFICE
7.8 OIL FILTER
7.9 COMPRESSOR OIL COOLING/AFTER COOLER SYSTEM
7.10 INSTRUMENTATION
7.11 COMPRESSOR DISCHARGE PRESSURE SWITCHGAUGE
7.12 HOURMETER
7.13 COMPRESSOR DISCHARGE AIR/OIL TEMPERATURE SWITCHGAUGE
7.14 ELECTRICAL AND SAFETY SYSTEM
7.15 ELECTRONIC ENGINE INTERFACE
7.16 AUTOMATIC BLOW DOWN VALVE
7.17 CONTROL SYSTEM
7.18 DISCHARGE PRESSURE REGULATOR VALVE
7.19 INLET VALVE
7.20 CONTROL SYSTEM OPERATION (ELECTRONIC ENGINES)
8 INSPECTION, LUBRICATION, AND MAINTENANCE
8.1 LUBRICATION AND MAINTENANCE CHART
8.2 LUBRICANT RECOMMENDATIONS
8.3 LUBRICANT CHARACTERISTICS
8.4 MAINTENANCE
9 TROUBLESHOOTING
9.1 TRUCK ENGINE WILL NOT START
9.2 UNPLANNED SHUTDOWN
9.3 IMPROPER DISCHARGE PRESSURE
9.4 SUMP PRESSURE DOES NOT BLOW DOWN
9.5 OIL CONSUMPTION
9.6 ENGINE PLUGGING
9.7 COALESCER PLUGGING
9.8 HIGH COMPRESSOR DISCHARGE TEMPERATURE
10 COMPRESSOR OPERATION
10.1 STARTING/STOPPING
10.2 OPERATING CONDITIONS
11 PARTS AND ILLUSTRATION SECTION
11.1 AIR/OIL SCHEMATIC
11.2 HOSE SYSTEM (100078)
11.3 CONTROL HOSE PORT CALL OUTS
11.4 AIR INLET SYSTEM (100081)
11.5 FRONT MOUNT OIL COOLER SYSTEM (60023K)
11.6 OIL COOLING SYSTEM (200140)
11.7 COMPRESSOR AND MOUNTING SYSTEM (100076)
11.8 DISCHARGE SYSTEM (100074)
11.9 ELECTRICAL SYSTEM (100077)
11.10 ELECTRICAL SYSTEM
11.11 PTO AND DRIVELINE SYSTEM (60000)
11.12 IMT MISCELLANEOUS PARTS BOX (AIR FILTER BOX)
11.13 MISC. PARTS LOCATED IN BOX
11.14 RECOMMENDED SPARE PARTS LIST
11.15 SERVICE QUESTIONNAIRE
12 INSTALLATION SECTION
12.1 GENERAL
12.2 Instructional Procedures
13 INSTALLATION ILLUSTRATIONS
13.1 PTO End Yoke Installation
13.2 Driveline Runout Specifications
13.3 Driveline Installation Techniques
13.4 ANGLE CHART
13.5 Side View Operating Angle Calculations with Up Hill Shaft
13.6 Side View Operating Angle Calculations with Down Hill Shaft
13.7 Oil Sump Mounting Configurations