John Deere 1654, 1854, 2054, 2104, 6165J, 6185J, 6205J and 6210J Tractors Technical Manual TM135719 01DEC18

Table of Content:

1 Introduction
1.1 Foreword
2 Contents
3 General Information
3.1 Safety Information
3.2 General References
4 Diagnostic Trouble Codes
4.1 BCU Diagnostic Trouble Codes
4.2 ECU Control Unit
5 Observable Symptoms
5.1 Electrical System
5.2 Electronic Control Units
5.3 PowrQuad Transmissions
5.4 Drive Systems
5.5 Steering and Brakes
5.6 Hydraulic System
5.7 Operator`s Cab
6 System Diagnosis
6.1 Electronics
6.2 Hydraulic System
7 Engine
7.1 General Information
7.2 Operational Checks
7.3 Tests and Adjustments
8 Fuel, Air Intake and Cooling Systems
8.1 Tests and Adjustments
8.2 Fuel System
8.3 Air Intake System
8.4 Cooling System
8.5 Cold-Weather Starting Aids
9 Electrical System
9.1 Fuse Box
9.2 Starting and Charging Circuit
9.3 CAN BUS and Service Connector
9.4 ECU – Power
9.5 ECU – Throttle and Fuel System
9.6 ECU – Fuel Preheater and Aid Heater
9.7 ECU – Sensors
9.8 BCU – Electronic Hitch-Control
9.9 BCU – Brakes
9.10 BCU – PTO
9.11 BCU – Front-Wheel Drive
9.12 BCU – Differential Lock
9.13 BCU – Wheel Speed Sensor
9.14 BCU – Turn Signal and Hazard Warning Lights
9.15 Panel Warning Lights
9.16 Lights, Tail Lights and License Plate
9.17 Work Lights
9.18 Radio, Dome Light, Console Light and Beacon Light
9.19 Horn and Accessories Socket
9.20 Power Outlet
9.21 Seat Compressor and Cigarette Lighter
9.22 Fan and A/C
9.23 Front Windshield Wiper and Washer
9.24 Rear Windshield Wiper and Washer
9.25 Trailer Connector
9.26 Wiring Harnesses
9.27 Connectors
10 Electronic Control Units
10.1 Operation and General Information on Diagnostics
10.2 Interactive Tests
10.3 Interactive Calibrations
10.4 Information on How to Reprogram Control Units
10.5 Data BUS Systems, Operation
10.6 BCU – Basic Control Unit
10.7 ECU Control Unit
11 PowrQuad Transmissions
11.1 Operational Check
11.2 Tests and Adjustments
11.3 Operation
11.4 Range Box
12 Drive Systems
12.1 Operational Check
12.2 Tests and Adjustments
12.3 Operation
13 Steering and Brakes
13.1 Preliminary Checks
13.2 Operational Check
13.3 Tests and Adjustments
13.4 Hydrostatic Steering
13.5 Brakes
13.6 Air brake system
14 Hydraulic System
14.1 Operational Check
14.2 Tests and Adjustments
14.3 Theory of operation
14.4 Oil Filter, Charge Pump and Hydraulic Pump
14.5 Hitch
14.6 Selective control valves (SCV)
14.7 Hydraulic block
15 Operator`s Cab
15.1 Tests and Adjustments
15.2 Operation
16 Special Tools (Dealer-Fabricated)
16.1 Special Tools (Dealer-Fabricated)
16.2 Special Tools (Available as Spare Parts)
17 Page Number
17.1 Section 210
17.2 Section 211
17.3 Section 212
17.4 Section 213
17.5 Section 220
17.6 Section 230
17.7 Section 240
17.8 Section 245
17.9 Section 255
17.10 Section 256
17.11 Section 260
17.12 Section 270
17.13 Section 290
17.14 Section 299