John Deere Models 5303, 5103, 5203, 5204, 5403 Technical Manual TM900019 September 2013

Table of Content:

1 Table of contents
2 FOREWORD
3 Section 10 – GENERAL INFORMATION
3.1 Group 05 – Safety
3.2 Group 10 – General Specifications
3.3 Group 15 – Fuel and Lubricants
3.4 Group 20 – Serial Number Locations
3.5 Group 25 – Features and Accessories
4 Section 20 – ENGINE REPAIR
4.1 Group 05 – Engine
4.2 Group 10 – Cylinder Head and Valves
4.3 Group 15 – Cyl. Block, Liners, Pistons & Rods
4.4 Group 20 – Crankshaft, Main Bearings and Flywheel
4.5 Group 25 – Camshaft and Timing Gear Train
4.6 Group 30 – Lubrication System
4.7 Group 35 – Cooling System
5 Section 30 – FUEL AND AIR REPAIR
5.1 Group 05 – Fuel System
5.2 Group 10 – Air Intake and Exhaust System
5.3 Group 15 – Speed Control Linkage
6 Section 40 – ELECTRICAL REPAIR
6.1 Group 05 – Battery, Starter and Alternator
6.2 Group 10 – Electrical System Components
6.3 Group 15 – Wiring Harness
7 Section 50 – POWER TRAIN REPAIR
7.1 Group 05 – Clutch Housing
7.2 Group 10 – Clutch Assembly
7.3 Group 15 – S Transmission
7.4 Group 20 – AA Transmission
7.5 Group 21 – Rear PTO (S Transmission)
7.6 Group 25 – Rear PTO (AA Transmission)
7.7 Group 26 – Differential
7.8 Group 30 – Final Drives
7.9 Group 35 – Mechanical Front Wheel Drive
8 Section 60 – STEERING AND BRAKE REPAIR
8.1 Group 05 – Steering Repair
8.2 Group 10 – Brake Repair (e Roll-GardRoll-Gard is a trademark of Deere & Company
11.4 Group 15 – Operator Platform
11.5 Group 20 – Fenders
11.6 Group 25 – Canopy (If Equipped)
12 Section 210 – OPERATIONAL CHECKOUT PROCEDURES
12.1 Group 10 – Operational Checkout Procedures
13 Section 220 – ENGINE OPERATION, TESTS AND ADJUSTMENTS
13.1 Group 05 – Component Location
13.2 Group 10 – Theory of Operation
13.3 Group 15 – Diagnosis, Tests and Adjustments
14 Section 230 – FUEL/AIR OPERATION, TEST AND ADJUSTMENTS
14.1 Group 05 – Component Location
14.2 Group 10 – Theory of Operation
14.3 Group 15 – Diagnosis, Tests and Adjustments
15 Section 240 – ELECTRICAL SYSTEM OPERATION, TESTS & ADJUST
15.1 Group 05 – Component Location
15.2 Group 10 – Theory of OperationLatin America, Mexico, USA and Australia (5103, 5203, 5303, 5403) Tractors
15.3 Group 15 – Theory of Operation?eors
15.5 Group 25 – Diagnosis, Test and AdjustUSA and Australia Tractors
15.6 Group 30 – Diagnosis, Test and Adjust (Mexico 5204 Tractors)
15.7 Group 35 – Wiring SchematicsLatin America, Mexico (5303), USA and Australia (5103, 5203, 5303, 5403) Tractors
15.8 Group 40 – Wiring SchematicsFor USA and Australia Tractors
15.9 Group 45 – Wiring Schematics (Mexico 5204 Tractors)
15.10 Group 50 – Component InformationConnectors(For USA and Australia Tractors)
16 Section 250 – POWER TRAIN OPERATION, TESTS AND ADJUSTMENTS
16.1 Group 05 – Component LocationTransmission
16.2 Group 10 – Theory of Operation?ef Operation
18.3 Group 15 – Diagnosis
18.4 Group 20 – Hydraulic Tests – Without SCV
18.5 Group 25 – Hydraulic TestsWith SCV
18.6 Group 18 – Hydraulic Tests?