Claas Ru-600 Contour (903) Forage Harvesters Operator Manual ES

File List:

00 0295 024 0.pdf

00 0295 024 0.pdf:

1 General view of the machine
2 Introduction
Introduction
Validity
4 Prologue
To observe in particular
Identification plate
Road transport
Protective device for road driving.
Lighting while driving on the road
Ballasted
5 Security measures
Warning and danger signs
Use in accordance with the intended standards
General safety and accident prevention rules
Safety decals with warning symbols
Security supports.
6 Technical data
RU 600 Contour
RU 600 Auto-Contour
7 Before start-up
Corn header loading and unloading
First assemble the corn header
Adaptations in the chopper
Additional weights
Additional weights required
Order numbers – additional weights
Additional lighting for road driving
Adjust descent speed
Mounting the protection plate
Assemble the corn header
Install the locking linkage.
Assemble the transmission for the feeding auger (for supplies to the USA)
Install the articulated shaft
Assemble the augers for lying corn
Assembly of dividing tips/guide fingers
Assemble the dividing tips
Assemble the guide fingers
Adjusting the dividing tips
Assemble the feed guide
Remove protection
Remove transport support
Checks and observations before start-up
Assemble the corn header
Proceed as described below to assemble the corn header:
Open interlock mechanism
Attach the corn header
Close interlock mechanism
Adjust the interlock mechanism
Adjust locking linkage
Connect the hydraulic system
Power supply connection
Connect the articulated shaft to the chopper
Adjust claw coupling
Rotating chassis
Unlock the pendulum track
Lock the pendulum track
Support legs
Working and transport position
Transport position
Work position
Dismantling/taking out of service the corn header
8 Management
Start up
Raise/lower corn header
Raise/lower corn header side arms
Use of the corn header
dividing tips
Adjust the angle of the dividing tips
Adjustment of the outer tips
Adjust the feed guide
Adjust the length of the chop
Cutting-chopper length sector
Adjust the spike bar
Adjust the blades
Adjustment of the coupling device
Harvesting laid corn
Additional equipment
Lying corn cone (D03 0070)
Deflector arc elevation (D03 0060)
CLAAS Autopilot (R03 0110)
Adjust the probes:
CLAAS Auto-Contour (R03 0070)
9 Maintenance
Important maintenance instructions
Replacement parts
Hydraulic system
Lubrication
Protection devices
Spur gear (A)
Angular transmission (B)
Main gear (C)
Bevel gear (D)
Angular transmission (E)
Rotor gear (F)
Puller gear (G)
Transmission (H, I) for the laid corn auger
Couplings
Drive chain lubrication
Tension the drive chain
Change the blades
Replace the blades:
spring tension
Swing chassis spring tension
Feed auger spring tension
Hydraulic system
Flexible hydraulic system pipes
Fixing elements
Screwed joints
Union elements
Care of the machine until new use
Lubricants table
10 Greasing scheme
Security measures
Lubricants table
Lubrication