bomag bw 28 rh pneumatic tyred roller electric training 00840189 1

bomag bw 28 rh pneumatic tyred roller electric training 00840189 2

bomag bw 28 rh pneumatic tyred roller electric training 00840189 3

bomag bw 28 rh pneumatic tyred roller electric training 00840189 4

bomag bw 28 rh pneumatic tyred roller electric training 00840189 5

Bomag BW 28 RH Pneumatic Tyred Roller Electric Training 00840189

$30.00

Type Of Manual: Electric Training
Manual ID: 00840189
Format: PDF
Size: 1.6MB
Number of Pages: 142
Serial Number:
101538401001 and up

Category: Bomag Service Manual PDF

Model List:
- BW 28 RH Pneumatic Tyred Roller

1. Table of contents
2. Training of electric system
2.1. General information
2.1.1. Known faults
2.1.2. Software versions
2.1.2.1. Software version schemes
2.1.2.2. Displaying version of firmware or software
2.1.2.3. Displaying build number
2.2. Notes on commissioning the machine
2.2.1. Initial commissioning of the controls
2.2.2. Checking the set serial number
2.2.3. Teaching the crossslope sensor from software version V1.05
2.3. Optional equipment
2.3.1. Activating/deactivating the AZ14 temperature gauge
2.3.2. Activating/deactivating the T3 tyre inflation system
2.3.3. Activating/deactivating the spraying system
2.3.4. Activating/deactivating the emulsion mixing system
2.4. Diagnostics system
2.4.1. Diagnostics system
2.4.1.1. Travel lever
2.4.1.2. Instrument cluster
2.4.2. Changing the unit system
2.5. Fault codes
2.5.1. Display fault codes
2.5.1.1. Displaying active faults of machine control
2.5.1.2. Displaying stored faults of machine control
2.5.2. BOMAG DTC fault code list
2.5.3. Deutz DTC fault code list, EMR4
2.5.4. Deleting stored fault codes
2.5.4.1. Deleting stored faults of machine control
2.5.4.2. Deleting stored faults of engine control unit
2.6. Input codes
2.6.1. Activate input mode
2.6.2. Activate service mode
2.6.3. Driving against the closed brake
2.6.4. EndOfLine (EOL) test
2.6.5. Input code list
2.7. Special tools
2.8. Measures after replacing or repairing components
2.8.1. Replacement of the ESX control
2.8.2. Replacement of engine components
2.8.3. Replacement of components SCR system
2.8.4. Replacing components with setup procedure
2.8.5. Replacing components without an adjustment procedure
2.8.6. Function test

Rate this product