Claas LEXION 530-520 MONTANA (582) Combine Operator Manual DE
$30.00
- Brand: Claas
- Model: LEXION 530-520 MONTANA (582) Combine
- Type Of Manual: Operator Manual
- Language: DE
- Format: PDF(s)
- Size: 73.9 MB
File List:
– 00 0293 656 7.pdf
– 00 0295 270 0.pdf
– 00 0299 528 1.pdf
00 0293 656 7.pdf
Table of Content:
1 1 Introduction
1.1 1.1 General information
2 2 General information
2.1 2.1 Road traffic
2.2 2.2 Particular attention should be paid
2.3 2.3 Type plate / serial number
2.4 2.4 Attachments / machine housing
3 3 For safety
3.1 3.1 Safety instructions
3.2 3.2 Safety sticker with warning symbols
4 4 Technical data
4.1 4.1 CLAAS LEXION 560 / 550 Montana
4.2 4.2 CLAAS LEXION 530 / 520 Montana
5 5 Before commissioning
5.1 5.1 General information
5.2 5.2 Cabin
5.3 5.3 Lighting and sockets
5.4 5.4 Promotion ladder
5.5 5.5 Side flaps
5.6 5.6 Mudguard / side panel / trailer frame / transport trolley
5.7 5.7 Steering axles (standard cleaning system)
5.8 5.8 Addiontrol
5.12 5.12 CLAAS autopilot (corn picker)
5.13 5.13 CLAAS autopilot (grain cutter)
5.14 5.14 Notes on coupling/uncoupling trailers
6 6 Attaching and removing the cutting unit
6.1 6.1 Attaching the cutting unit
6.2 6.2 Dismantling the cutting unit
7 7 Operation CEBIS (version 8.23)
7.1 7.1 CLAAS on-board information system CEBIS
7.2 7.2 CEBIS monitor and rotary switch
7.3 7.3 Rotary switch D
7.4 7.4 Before initial commissioning
7.5 7.5 Driving image
7.6 7.6 Harvest image
7.7 7.7 Montana regulation
7.8 7.8 CLAAS CRUISE PILOT
7.9 7.9 Yield Mapping
7.10 7.10 Flagging
7.11 7.11 GPS
7.12 7.12 Presets Haspel
7.13 7.13 Presets attachment
7.14 7.14 Section switching
7.15 7.15 Yield measuring device
7.16 7.16 Yield measurement
7.17 7.17 Fruit-dependent setting
7.18 7.18 Register
7.19 7.19 Setting
7.20 7.20 Motor utilization
7.21 7.21 Alarms
7.22 7.22 Messages
7.23 7.23 Malfunction / Remedy – Yield Measuring Device
7.24 7.24 Guide values for pulses/100 m
8 8 Operation – basic machine
8.1 8.1 Feed channel
8.2 8.2 Threshing organs
8.3 8.3 Shaker
8.4 8.4 Cleaning (standard cleaning system)
8.5 8.5 Grain recovery
8.6 8.6 Straw chopper with standard distributor
8.7 8.7 Chaff spreader
8.8 8.8 Straw distributor
8.9 8.9 Sieving and threshing tables LEXION 560 – 520 Montana (standard cleaning system)
8.10 8.10 Unawning
8.11 8.11 Malfunction, cause or remedy – basic machine
9 9 Maintenance – basic machine
9.1 9.1 Important maintenance instructions
9.2 9.2 Maintenance tables
9.3 9.3 Lubricant tables
9.4 9.4 Hydraulic system
9.5 9.5 Gearbox
9.6 9.6 Feed channel
9.7 9.7 Drive axis
9.8 9.8 Elevator chains
9.9 9.9 Drive belts / drive chains
9.10 9.10 Cabin / Air conditioningWinterization
10 10 Maintenance – Motor
10.1 10.1 Important maintenance instructions
10.2 10.2 Maintenance tables
10.3 10.3 Lubricant tables
10.4 10.4 Engine overview
10.5 10.5 Fuel system / engine oil
10.6 10.6 Cooling system
10.7 10.7 Dry air filter
10.8 10.8 Three-phase generator
10.9 10.9 Electrics / Electronics
10.10 10.10 Malfunction, possible cause or remedy
10.11 10.11 Winterization
11 11 Lubrication plan
11.1 11.1 Lubrication points
00 0295 270 0.pdf
Table of Content:
2 1 Introduction
2.1 1.1 General information
3 2 Before commissioning
3.1 2.1 Combine harvesters drive with mechanical / electro-hydraulic drive control
4 3 Maintenance – basic machine
4.1 3.1 Lubricant tables
5 4 Maintenance Motor
5.1 4.1 Maintenance tables
7 1 Introduction
7.1 1.1 General Information
8 2 Prior to operation
8.1 2.1 Driving the combine with mechanical / electro-hydraulic ground drive control
9 3 Maintenance – Basic machine
9.1 3.1 Lubricants charts
10 4 Engine maintenance
10.1 4.1 Maintenance schedules
12 1 Introduction
12.1 1.1 General Councils
13 2 Avant la mise en service
13.1 2.1 Conduite de la moissonneuse-batteuse with commande mecanique / lectrohydraulique d’avancement
14 3 Entretien – machine de base
14.1 3.1 Tableaux des lubricants
15 4 Maintenance motor
15.1 4.1 Tableaux dentretien
17 1 Introduction
17.1 1.1 General indications
18 2 Prima della messa in esercizio
18.1 2.1 Advancement of the rental engine with mechanical command / electric hydraulic
19 3 2.1 1.1 General indications
23 2 Antes de la puesta en marcha
23.1 2.1 Conducir the cosechadora with an accionamiento del advance mecnico / electro-hidrulico
24 3 Mantenimiento – Machine base
24.1 3.1 Cuadros de lubricants
25 4 Mantenimiento del motor
25.1 4.1 Tablas de mantenimiento
00 0299 528 1.pdf
Table of Content:
1 Introduction
1.1 Introduction
2.1 Content
3 General information
3.1 Road traffic
3.2 Particular attention should be paid to
3.3 Type plate / serial number
4 For safety
4.1 For safety
4.2 Safety sticker with warning symbols
5 Technical data
5.1 CLAAS LEXION 560 / 550 Montana
5.2 CLAAS LEXION 530 / 520 Montana
5.3 Safety devices
6 Before commissioydraulic cylinder
6.11 Grain tank
6.12 Driving a combine harvester
6.13 CLAAS autopilot (corn picker)
6.14 Malfunction, possible cause or remedy slope device
7 cutting unit on-anddismantling
7.1 Attaching the cutting unit
7.2 Dismantling the cutting unit
8 Operation CEBIS
8.1 Content
8.2 CLAAS on-board information system CEBIS
8.3 CEBIS monitor and rotary switch
8.4 Rotary switch D
8.5 Before initial commissioning
8.6 Driving image
8.7 Harvest image
8.8 Flagging
8.10 Presets Haspel
8.11 Presets attachment
8.12 Section switching
8.13 Yield measuring device
8.14 Yield measurement
8.15 Fruit-dependent setting
8.16 Register
8.17 Setting
8.18 Motor utilization
8.19 Alarms
8.20 Messages
8.21 Malfunction / Remedy – Yield Measuring Device
8.22 Guide values io4 Cleaning
9.5 Grain recovery
9.6 Straw chopper
9.7 Chaff spreader / straw spreader
9.8 Sieving and threshing tables LEXION 560 520 Montana
9.9 Malfunction, cause or remedy basic machine
10 Maintenance basic machine_x0004_
10.1 Important maintenance instructions
10.2 Maintenance and lubricant tables
10.3 Hydraulic system
10.4 Gearbox
10.5 Feed channel
10.6 Drive axis
10.7 Elevator chains
10.8 Drive belts / drive chains basic machine
10.9 Cabin / Air conditioning
10.10 Fire extinguisher_x0004_
10.11 Compressed air system (additional equipment)
10.12 Straw chopper
10.13 Winterization suggestions for combine harvesters
11 Maintenrization suggestions for engines_x0004_
12 Lubrication plan
12.1 Lubricants and information
13.1 Index
Claas Operator Manual PDF
Claas QUANTUM 6800-4500 GT P (615) Loader Wagons Operator Manual DE
Claas Operator Manual PDF
Claas QUANTUM 5500 S S16 S18 4500 S (614) Loader Wagons Operator Manual DE
Claas Operator Manual PDF