Claas S900-S450 Soja Lexion Tucano (440) Combines Operator Manual ES

File List:

00 0293 261 0.pdf

00 0293 261 0.pdf:

Introduction
Introduction
General indications
Important notes
factory plate
Security measures
Security measures
Safety supports
Positioning hole
Pinwheel
Safety stickers with danger symbols
Before start-up
Tasks to be carried out before the first start-up
Remove the transport supports
Adjust the cutting table compensation springs
Place the hydraulic cylinder of the right cutting table.
Engage the third hydraulic cylinder
Connecting bar for machines equipped with CLAAS-CONTOUR (without transverse adjustment)
Assemble the tie bar
Attach the cutting table
Adjust the hydraulic cylinder for transversal adaptation of the cutting table
Couple the cardan shafts
Attach the quick plug
Disassemble the cutting table
Adjustments on the cutting table
Cutting table skids
Pinwheel
reel tines
Horizontal reel adjustment
Mountain range
Standard type saw
Standard saw settings
Saws type SG3/S and SG3
Adjust saws type SG3/S and SG3
Feed auger
Adjust the distance with respect to the bottom plate
Vary the position of the feed finger control
Change the degree of inclination of the cutter bar
harvest dividers
Adjust the tips of the crop dividers
Basic setting of crop dividers
Replace the tips of the crop dividers
Mount the supplement on the tips of the long crop dividers
Transformation from soy to cereal
Dismantle the soybean probes
Assemble the probes
Change and regulate sensors
Adjusting the sensor control levers in relation to the end stops
Lock the cutter bar
Transformation from cereal to soybeans
Change and regulate sensors
Adjusting the sensor control levers in relation to the end stops
Assemble the probes for soybeans
Unclip the outer skid of the transverse suspension arm
Remove the cutter bar locking screws
Maintenance
Lubricants and maintenance table
Maintenance table
Lubricants table
Gearbox – Saw Drive
Oil level check / Oil change
Adjust gearbox support
Tension cylinder adjustment
Drive belts/chains
Remove the drive belts/chains (40)
Install the drive belts (40) of the cutter bar
Tighten the feed auger drive chain (41)
Tension the reel drive chain
Inductive transmitter for the reel drive
Greasing scheme
Lubricants and indications
Alphabetical index
Alphabetical index