Table of Content:
1 ELECTRONIC MANUALS
2 REVISIONS LIST
3 INTRODUCTION
4 SPECIFICATIONS
4.1 PERFORMANCE CHARACTERISTICS
4.2 POWER SOURCE
4.3 SPECIFICATIONS
4.4 CYLINDER HOLDING VALVES
4.5 ROTATION SYSTEM
4.6 HYDRAULIC SYSTEM
4.7 OPERATOR’S STATION
4.8 MINIMUM CHASSIS SPECIFICATIONS
4.9 RECOMMENDED CHASSIS SPECIFICATIONS
4.10 GEOMETRIC CONFIGURATION – 8000L / 25′ BOOM
4.11 GEOMETRIC CONFIGURATION – 8000L / 21′ BOOM
4.12 OUTRIGGER DIMENSIONS
4.13 CAPACITY CHART-8000L CRANE
5 CRANE REFERENCE
5.1 MAJOR CRANE ASSEMBLIES
5.2 GREASE ZERK LOCATIONS & LUBRICANT REQUIREMENTS
5.3 RECOMMENDED SPARE PARTS LIST
5.4 JOYSTICK CONTROLS
5.5 PRECAUTIONS
6 PARTS
6.1 PARTS INFORMATION
6.2 STEM ASM (41713739)
6.3 OUTRIGGER CYLINDER (3B025920)
6.4 MAST ASM-650 ROT’N (41714943-1)
6.5 MAST ASM-650 ROT’N (41714943-2)
6.6 MAST A INNER BOOM ASM-21′ (41714946)
6.10 INNER BOOM ASM-25′ (41714944)
6.11 INNER BOOM CYLINDER (3C152980)
6.12 OUTER BOOM ASM-21′ (41714945)
6.13 OUTER BOOM ASM-20′ (41714749)
6.14 OUTER & EXT BOOM ASM-25′ (41714947)
6.15 OUTER BOOM CYLINDER (3C092950)
6.16 EXTENSION BOOM CYLINDER (3B275960)
6.17 CONTROL KIT-8F 25′ (41714950)
6.18 VALVEBANK ASM 5-SECT RH (51714970)
6.19 VALVEBANK ASM 4-SECT LH 21′ (51714971)
6.20 VALVEBANK ASM 4-SECT LH 25′ (51714972)
6.21 HYDRAULIC KIT-7F-21′ 650 ROT’N (91714949)
6.22 HYDRAULIC KIT-8F-25′ 650 ROT’N (91714968)
6.23 HYDRAULIC KIT-7F-21′ CONT ROT’N (91715018)
6.24 HYDRAULIC KIT-8F-25′ CONT ROT’N (91714983)
6.25 INSTALLATION KIT-FRONT MNT (93712607)
6.26 DECAL KIT-21′ (95714990)
6.27 DECAL KIT-25′ (95714991)
6.28 GRAPPLE MTG KIT-NON DAMPENED-S&L (51711384)
6.29 GRAPPLE MTG KIT-DAMPENED-S&L (51712053)
6.30 2 GRAPPLER RECOMMENDATION / CORRECTIVE ACTION REPORT
7.3 WIRE ROPE INSPECTION
7.4 HOOK INSPECTION
7.5 HOLDING VALVE INSPECTION
7.6 TWO BLOCK PREVENTION DEVICE INSPECTION
7.7 TORQUE DATA CHART – DOMESTIC
7.8 TORQUE DATA CHART – METRIC
7.9 TURNTABLE BEARING FASTENER TIGHTENING SEQUENCE
7.10 TURNTABLE BEARING INSPECTION FOR REPLACEMENT
8 CRANE SAFETY
9 VOLUME 1
10 WARRANTY POLICY