Kubota CM 280 Parts Manual

Table of Content:

1 INDEX
2 ENGINE
2.1 Engine
2.2 Motor Supports
2.3 Clutch
2.4 Air Filter
2.5 Water radiator
2.6 Silencer
2.7 Fuel tank
3 TRANSMISSION
3.1 Transmission support
3.2 Reducer support
3.3 Gear shift levers
3.4 Reducer
3.5 Compen System
3.6 Clutch bell
3.7 Gearbox
3.8 Speed change
3.9 Front bridge cardan joint
3.10 Rear bridge cardan joint
3.11 Front axle
3.12 Rear axle
4 FRAME
4.1 Frame
5 THROTTLE
5.1 Accelerator
6 CLUTCH
6.1 Clutch control
7 BRAKE
7.1 Brake Actuation
8 ADDRESS
8.1 Engine and Silencer Diter
8.2 Address Column
9 WHEELS
9.1 Wheel
10 BODY
10.1 Conductive protector and covers
10.2 Simple conductive protector
10.3 Driver’s seat
10.4 Engine protector
10.5 Counterweights and plates
10.6 Bolt
11 MACHINE OPERATION IMPLEMENTS
11IRCUIT INSTALLATION
12.1 Hydraulic tank
12.2 Distributor
12.3 Hydrostatic group
13 ELECTRICAL INSTALLATION
13.1 Electrical installation
13.2 Installation of cables
14 PLATES
14.1 Plates
15 LATERAL SHIFT BOARD
15.1 Lateral movement
15.2 Displacement cylinder
15.3 Tubes
15.4 Board accessories
15.5 Hydraulic installation Mast 3.6 M. – 4.5 M.
15.6 Hydraulic installation Mast 5.4 M. – 6.75 M.
16 LEVELING CYLINDER
16.1 Supports
16.2 Leveling accessories
16.3 Hydraulic installation
16.4 Lateral leveling
16.5 Tensioning body – level
16.6 Indicator light connector
17 MAST
17.1 Duplex mast Mast 4.5 M.
17.2 Mast chain assembly 4.5 M.
17.3 Mast lifting cylinders 4.5 M.
17.4 Mast pulley support 4.5 M.
17.5 Hydraulic installation Mast 4.5 M.
17.6 Triple mast Mast 5.4 M.
17.7 Mast cylinder chains 5.4 M.
17.8 Hydraulic installation Mast 5.4 M.
17.9 Mast chain assembly 5.4 M.
17.10 Mast lifting cylinders 5.4 M.
17.11 Mast pulley support 5.4 M.
17.12 Triple mast Mast 6.75 M.
17.13 Fork carrier plate 6.75 M.
17.14 Cylinder chains 6.75 M.
17.15 Pulley support 6.75 M.
17.16 Lifting cylinders 6.75 M.
17.17 Chain assembly 6.75 M.
17.18 Hydraulic installation 6.75 M.
17.19 Triple mast folding 6.75 m. – Duplex 4.5 m.
18 LOAD REDUCTION DEVICE
18.1 Mast solenoid valve 5.4 – 6.75 M.
18.2 Mast tensioning body 5.4 – 6.75 M.
18.3 Mast tensioning body 5.4 – 6.75 M.
18.4 Complete conductive protector
19 BODY
19.1 Heater application
19.2 Heater application
19.3 Load protector
19.4 Rearview mirror
20 INDEX OF REFERENCES